On/Off Button; Mode Button - MESTIC RTA-2500 Instrucciones De Uso

INTRODUCTION FOR BUTTONS ON REMOTE CONTROLLER
Note:
• This is a universal remote controller, it can be used for multifunctional air conditioners. If an air conditioner model
does not have a specific function, and the corresponding button is pressed, the unit will continue running in its
original status.
• After turning on the power, the air conditioner will give out a sound and the operation indicator "
you can operate the air conditioner through the remote controller.
• When the power is on, every time a button is pressed on the remote controller, the signal icon "
remote controller will flash once. The air conditioner will give out a sound, which indicates the signal has been sent
to the air conditioner.

1. On/off button

•
Press this button to turn the air conditioner on. Press this button again to turn the air conditioner off.

2. Mode button

•
Press this button to select your required operation mode.
AUTO
•
In "AUTO" mode, the air conditioner will automatically operate according to the ambient temperature. The set
temperature cannot be changed and will not be displayed. By pressing the "FAN" button, the fan speed can be
adjusted.
•
In "COOL" mode, press the "+" or "-" button to change the set temperature. To adjust the fan speed, press
the "FAN" button.
•
In "DRY" mode, the air conditioner operates at low speed. The fan speed cannot be adjusted.
•
In "FAN" mode, only the fan is turned on, without any cooling or heating. Press the "FAN" button, to adjust the
fan speed.
•
In "HEAT" mode, press the "+" or "-" button to change the set temperature. To adjust the fan speed, press the
"FAN" button.
Note:
•
After the "HEAT" mode is selected, the air conditioner will delay air blowing 1-5 minutes, to prevent blowing
cold air. (The actual delay time depends on the indoor ambient temperature.)
•
The temperature can be set between 16-30°C (61-86°F).
3. Fan button
•
This button is used for setting the fan speed in the following sequence:
AUTO
Low fan
Note:
•
In "AUTO" speed mode, the air conditioner will automatically select the proper fan speed according to the
default setting.
•
In "DRY" mode, the fan speed is low.
•
"X-FAN" function: when the "FAN" button is pressed for 2 seconds in "COOL" or "DRY" mode, the icon "
is displayed and the indoor fan will continue operation for a few minutes in order to dry the indoor unit, even
when the unit is turned off. If the "FAN" button is now pressed for 2 seconds, the fan will stop immediately.
"X-FAN" is not available in auto, fan or heat mode.
COOL DRY
Middle fan
FAN HEAT
High fan
" is on. Now,
" on the
"
13