Cleaning And Storage; Troubleshooting - Craftsman WEEDWACKER 316.896420 Manual Del Operador

CLEANING
WARNING:
To avoid serious personal injury, always stop
the engine and allow it to cool before cleaning or maintaining
the unit.
Use a small brush to clean the outside of the unit. Do not use strong
detergents. Household cleaners that contain aromatic oils such as
pine and lemon, and solvents such as kerosene, can damage plastic.
Wipe off any moisture with a soft cloth.
PROBLEM
THE ENGINE WILL NOT START
The fuel tank is empty
The primer bulb was not pressed enough
The engine is flooded
The fuel is old (over 30 days) and/or improperly mixed
The spark plug is fouled
THE ENGINE WILL NOT IDLE
The air filter is dirty
The fuel is old (over 30 days) and/or improperly mixed
The idle speed is incorrect
THE ENGINE WILL NOT ACCELERATE
The fuel is old (over 30 days) and/or improperly mixed
The air filter is dirty
THE ENGINE LACKS POWER OR STALLS
The fuel is old (over 30 days) and/or improperly mixed
The air filter is dirty
The spark plug is fouled

CLEANING AND STORAGE

STORAGE
• Never store a fueled unit where fumes may reach an open flame
or spark.
• Allow the engine to cool before storing.
• Lock up the unit to prevent unauthorized use or damage.
• Store the unit in a dry, well-ventilated area.
•
Store the unit out of the reach of children.
Short-term Storage (1-2 weeks)
1. Store the unit in a horizontal position. If this is not possible, store
the unit vertically with the engine at the top.
Long-term Storage
1. Remove the fuel cap, tip the unit and drain the fuel into an
approved container. Reinstall the fuel cap.
2. Start the engine and allow it to run until it stalls. This ensures
that all fuel has been drained from the carburetor.
3. Allow the engine to cool. Remove the spark plug and put 5 drops
of any high quality motor oil or 2-cycle oil into the cylinder. Pull the
starter rope slowly to distribute the oil. Reinstall the spark plug.
4. Thoroughly clean the unit and inspect it for any loose or
damaged parts. Repair or replace damaged parts and tighten
loose screws, nuts or bolts.
Preparing the Unit for Use after Long-term Storage
1. Remove the spark plug and drain all of the oil from the cylinder.
NOTE: Do not use fuel that has been stored for more than 30 days.
Dispose of old fuel according to federal, state and local regulations.

TROUBLESHOOTING

SOLUTION
Fill the fuel tank with properly mixed fuel
Press the primer bulb 10 times or until fuel is visible
Squeeze the throttle control and pull the starter rope until the engine
starts
Drain the fuel tank and add fresh, properly mixed fuel
Replace the spark plug
Clean or replace the air filter
Drain the fuel tank and add fresh, properly mixed fuel
Adjust the idle speed
Drain the fuel tank and add fresh, properly mixed fuel
Clean or replace the air filter
Drain the fuel tank and add fresh, properly mixed fuel
Clean or replace the air filter
Replace the spark plug
13