Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Service
7.5
Error codes
The meter has one error code that may display. It provides an indication, at the meter,
that there is an error in communication between the meter and keypad.
SF0 (scale factor 0) the scale factor setting for the meter is set to 0.000.
• To input a valid scale factor for the meter follow the instructions in chapter 9 "Change
factory settings".
All other Error Codes are for factory purposes only.
• To clear the meter, press reset.
8. Service
8.1
Low battery
When the batteries need to be exchanged, a progression of warnings appears on the
meter screen.
Low battery icon
8.2
Changing the batteries
The battery compartment is located in the lower case on the underside of the trigger
guard.
1. Turn the unit over.
2. Unscrew the two screws. Remove the battery door to expose the batteries.
3. Replace the old batteries. The meter takes 4 AA, alkaline, batteries.
NOTE: Battery polarity markings are inside battery compartment.
4. Dispose of used batteries properly, according to local regulations.
NOTE: Changing the batteries does not affect any of the programmed values or totals.
First warning: The low battery icon appears in the
lower left corner of the display. That means the
batteries are low and need to be exchanged.
Second warning: Battery icon flashes. The battery
power is too low and meter functions are disabled.
LM_OGP2Adv_BA_89_1008
page 32/92
Tabla de contenido
Solución de problemas
