Safety Instructions - YATO YT-82285 Manual De Instrucciones

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 34
PRODUCT SPECIFICATION
The heat gun is an electrical device designed to produce hot airfl ow at high temperatures. Air at this temperature facilitates,
among others, removal of old oil paints and varnishes from e.g. furniture, wainscoting, fl oors, doors, windows, etc. The device
is not intended for commercial use. The correct, reliable and safe operation of the device depends on its proper use, therefore:
Read the entire manual before the fi rst use of the device, and keep it for future reference.
The device supplier shall not be liable for any damage resulting from failure to comply the safety instructions and recommenda-
tions specifi ed in this manual.
DEVICE EQUIPMENT
The heat gun is equipped with additional nozzles. The accessories do not include the battery and a charging station.
TECHNICAL PARAMETERS
Parameter
Catalogue No.
Rated voltage
Airfl ow temperature
Airfl ow speed
Insulation class
Net weight
Protection rating

SAFETY INSTRUCTIONS

Irresponsible use of equipment can cause fi re, therefore exercise caution when using the
equipment in areas where combustible materials are present; do not direct a stream of hot
air at the same spot for an extended period of time; do not use the equipment in an explosive
atmosphere; be aware that heat may be transferred to combustible materials out of sight;
place the equipment on its stand after use and leave it to cool down before storage; do not
leave the equipment unattended when switched on. Before starting work, make sure that the
housing and the power cord and plug are not damaged. In case of damage, do not proceed
with work. This device must not be used by children. Children should not play with the device.
Children left unattended should not be allowed to perform the cleaning and maintenance of
the device. This device may be used by persons with reduced physical, mental abilities and
persons with no experience or knowledge of the device, if supervised or instructed on its safe
use so that the risks associated with it are understood. The device is not designed to operate
in high humidity conditions. The temperature at the place of the device's use must be within
the range of +10
densation. Do not expose the device to precipitation. WARNING! The metal components of
the device can be hot during and immediately after use. Do not touch them, as it may cause
severe burns. Allow the device components to cool down. Use gloves which protect against
high temperatures if you need to move these components before they cool down. Make sure
that the fl oor near the place of use of the appliance is not slippery. This will prevent slipping,
which can cause serious injuries. Never block or restrict the throughput of the heat gun's
air inlet openings. Never point the device at people or animals. Do not check the blowing
temperature by directing the air stream towards any part of the body. Never use the device
O R I G I N A L
8
C ÷ +38
C, and the relative humidity must be below 70% without con-
O
O
GB
Unit
[V]
[ºC]
[l/min.]
[kg]
I N S T R U C T I O N S
Value
YT-82285
18 d.c.
20 (1) / 550 (2)
- (1) / 100 (2)
III
0,7
IP20
Tabla de contenido
loading

Tabla de contenido