AEG IPE84571FB Manual De Instrucciones página 20

20 www.aeg.com
Problem
You cannot select the maxi‐
mum heat setting for one of
the cooking zones.
You cannot activate one of
the cooking zones.
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactivated.
The hob deactivates.
Residual heat indicator does
not come on.
Hob²Hood does not work.
The sensor fields become
hot.
There is no sound when you
touch the panel sensor
fields.
The flexible induction cook‐
ing area does not heat up
the cookware.
Possible cause
There is water or fat stains
on the control panel.
The other zones consume
the maximum available pow‐
er.
Your hob works properly.
You put something on one or
more sensor fields.
You put something on the
sensor field .
The zone is not hot because
it operated only for a short
time or the sensor is dam‐
aged.
You covered the control pan‐
el.
You use a very tall pot which
blocks the signal.
The cookware is too large or
you put it too near to the
controls.
The sounds are deactivated. Activate the sounds. Refer to
The cookware is in a wrong
position on the flexible in‐
duction cooking area.
Remedy
Clean the control panel.
Reduce the heat setting of
the other cooking zones con‐
nected to the same phase.
Refer to "Power manage‐
ment".
Remove the object from the
sensor fields.
Remove the object from the
sensor field.
If the zone operated suffi‐
ciently long to be hot, speak
to an Authorised Service
Centre.
Remove the object from the
control panel.
Use a smaller pot, change
the cooking zone or operate
the hood manually.
Put large cookware on the
rear zones, if possible.
"Daily use".
Place the cookware in the
correct position on the flexi‐
ble induction cooking area.
The position of the cookware
depends on the activated
function or function mode.
Refer to "Flexible induction
cooking area".