Electrical Connection - SFA Sanisub Steel Manual De Funcionamento

EN

3.3 ELECTRICAL CONNECTION

Only carry out the electrical
connections
hydraulic connections have been completed.
The electrical installation must be carried out
by a qualified electrical professional.
All wiring must conform to national standards
for electrical installations.
3.4 FITTING
Install the pump and ensure that it is stable.
If the pump is inserted into a pit or a duct,
its dimensions must allow the float switch to
move freely.
4. COMMISSIONING
Prior to commissioning, check
the pump for possible external
damages (e.g. transport damages) in order to
prevent accidents with electrical current.
Risk of cutting.
Never touch moving parts.
• Place the pump in an initial water level of at
least 60 mm to allow priming.
• Carry out a test run.
• Check the freedom of movement of the float.
• Avoid dry running, without pumped fluid.
5. USE
The inlet strainer must not be clogged by mud
and/or fibrous media.
The heights required by the float to start and
stop the pump can be changed by attaching
the float cable to the handle.
Note: The pump is equipped with an automatic
reset thermal protection.
6. MAINTENANCE
Disconnect the electrical supply
before carrying out work on the
unit!
Maintenance consists of checking and cleaning
the strainer:
• Turn over the pomp.
• Undo the screws.
• Remove and clean the strainer.
• Reassemble the strainer by following the
opposite procedure.
7. MALFUNCTIONS: CAUSE AND
TROUBLESHOOTING
after the final
8. STANDARDS
This piece of equipment complies with the
directives and European standards on electric
safety and electromagnetic compatibility.
9. DISPOSAL
recovery of any form of used appliances
contribute
environment.
10. GUARANTEE
Sanisub Steel is guaranteed for 2 years for
parts and labour, subject to correct installation
and use of the unit.
10
Malfunction Cause
Motor does Supply voltage
not rotate. missing or
wrong.
Faulty
connection.
Defective power
cable.
Impeller blocked. Clean.
Activated motor
protection
(overheating,
blockage,
voltage error or
other defect).
Float
suspended.
Motor defective. Replacement
Motor Impeller clogged
rotates, but or worn.
does not
Discharge pipe
convey.
clogged/hose
kinked.
Strainer clogged. Clean.
Feed Pump not
volume too properly
low. ventilated (air
bubble int the
housing).
Discharge pipe
dimensioned
too small.
The pump Water too dirty. Unplug and
stops too
quickly.
Pump blocked.
Thermical
protection on.
The device must not be disposed of as
household
disposed of at a recycling point for
electrical equipment. The device's
materials
reusable. The disposal of electrical
and electronic waste, recycling and
to the
Troubleshooting
Check power
supply.
Correct
connection.
Replacement
(Customer
service).
Check, inform
customer
service.
Change the
position of the
pump.
(Customer
service).
Clean/Replace
Clean/Remove
kinks.
Remove air by
tilting the pump.
Min. diameter of
25 mm.
clean.
Unplug and
clean.
Check the water
temperature (see
2.4 Technical
data).
waste and must
and components
preservarion of
be
are
our