Testing The Operation Of The Detector; Testing The Operation Of The Detector With The System; Replacing The Batteries - SOMFY 1875141 Manual

Testing the operation of the detector

Switch 1: Detection test
(Switch delivered in ON position by default)
Set switch 1 ("operating test") to ON and replace the
cover: the red indicator on the front comes on when the
detector is triggered.
Switch 1 MUST be returned to OFF after
test mode.
Switch 2 :
Do not change the position of this
switch (check that switch 2 is set to OFF).
Switch 3 :
Do not change the position of this switch (check that switch 3 is set to OFF).

Testing the operation of the detector with the system

1
Replace and
close the cover and
tighten the screw.
Maintenance

Replacing the batteries

Caution : risk of explosion if the battery is replaced by an incorrect type.
Keep the product and the batteries (new and used) out of reach of children. If the battery compartment does not
close securely, stop using the product and keep it out of reach of children. There is a risk of explosion or leakage
of flammable liquid or gas from the battery if it is kept at high temperature (hot oven or fire), crushed, cut, or
subjected to extremely low air pressure. Non-rechargeable batteries must not be charged.
1
Disable the installation's tamper switch to avoid triggering the alarm:
Enter the user code on the keypad and then press the OFF key until the
■
indicator goes out.
Or press the OFF key on the remote control until the indicator goes out.
■
You have 2 minutes to open the relevant part.
Copyright © 2018 Somfy Activités SA. All rights reserved.
OFF
ON
2
Arm the alarm system.
Wait for 2 minutes before passing in front of the
detector.
The operation of the detector must comply with
the choices in the table on page 5.
L
M
H
Keypad:
Clavier :
CODE +
57