Connecting Power - Uline H-9884 Manual

WARNING! Read all safety warnings before
installing, making connections or servicing this
scale. Failure to comply with these warnings
could result in personal injury and/or property
damage. Retain these instructions for future
reference.
• Verify that the AC adapters input voltage range
and plug type are compatible with the local AC
mains power supply.
• Position the instrument so that the AC adapter can
be easily disconnected from the wall socket.
• Position the power cord so that it does not pose a
potential obstacle or tripping hazard.
TRANSPORTATION LOCK
1. Rotate the
pointer on the
transportation lock
to the unlocked
position.
(See Figure 1)
NOTE:
Transportation
lock is located
on underside
of scale.
LOCATION
NOTE: Use on a firm, steady surface.
NOTE: Avoid locations with excessive air current,
vibrations, heat sources or rapid temperature
changes.
1. Adjust the leveling feet so level bubble is centered in
circle. (See Figure 2)
Figure 2
Leveling
Feet
PAGE 2 OF 24
Figure 1
Locked
Position
Pointer
Unlocked
Position
Balanced
Level
Bubble
Unbalanced
SAFETY
• Operate the unit only under ambient conditions
specified in these instructions.
• Scale is for indoor use only.
• Do not operate in hazardous or explosive
environments.
• Only use in dry locations.
• Only use approved accessories and peripherals.
• Disconnect from power supply when cleaning.
• Service should only be performed by authorized
personnel.
SETUP

CONNECTING POWER

BATTERY
1. Remove battery cover and install four C batteries
using the polarity indications as shown in the battery
compartment. (See Figure 3)
AC ADAPTER
NOTE: The AC adapter is used to power the
balance when battery power is not needed.
2. Connect the AC adapter plug to the input jack.
(See Figure 3)
Figure 3
Input
3. Connect AC adapter (supplied) to the proper AC
supply.
Battery
Cover
0422 IH-9884