How To Operate - Lavor CLEAN4SWIM Instrucciones De Montaje

in the bathroom) only connect it to sockets
which are connected in series with a ground
fault circuit interrupter. In case of doubt,
consult an electrician.
•Periodically examine the mains cable and
machine for damage. If any damage is
found, do not use the appliance but contact
your service centre for repair.
•If the suplly cord is damaged, it must be
replaced by the manufacturer, its service
agent or similary qualified persons in order
to avoid a hazard.
•Should extension cables be used, ensure
that these lay on dry surfaces and protected
against water jets.
•The use of extension leads, connectors or
adaptors that do not conform to the applicable
regulations is not permitted.
•If the equipment should overturn it is
recommended that the machine should be
stood up before switching off.
•Aggressive solvents or detergents should not
be used.
•The machine must be always used on
horizontal bases.
•Keep the machine on plane surfaces.
•The equipment should not be used to pick up
water from containers, lavatories, tubs, etc.
•These machine are not designed for
picking up health endangering dusts or
inflammable/explosives substances.
•Before vacuuming liquids, check the float
functions correctly.When vacuuming liquids,
and when the tank is full, a fl oat closes the
suction opening, and the vacuum operation
is interrupted. Then switch off the machine,
disconnect the plug and empty the tank.
Regularly clean the water level limiting device
(fl oat) and examine it for signs of damage.
•If foam/liquid should come from the machine
exhaust switch off immediately.
•Do not use the machine without proper filters.
•For wet & dry vacuum function, always put the
stopper (F) on the tank (I).
•Service and repairs must be carried out
by qualified personnel only. Only use
manufacturer original spare parts for service
repair.
•The manufacturer cannot be held responsible
for any damage/injury caused to persons,
animals or property caused by misuse of the
appliance, not in compliance with manual
instructions.
POOL CLEANER WARNINGS
•The equipment should not be used for the
emptying of pond and/or artificial lake,
lavatories, tubes, etc.
•Assembly always cleaner nozzle (O) or the
accessory (N+P) on the extensions (M).
•While placing the machine please keep safety
distance of 2 mt from the pond/lake border.
•Do not use the machine when people are
inside the pond/lake.
•Do not use the machine when it rains.
•The machine must be always kept on horizontal
bases, in a safe and stable way.
•While working, do not drag the flexible hose in
order to move the machine.
•While machine is working keep it under control.

HOW TO OPERATE

POOL CLEANER USE
(fig. ⑧⑨⑩⑪⑫)
• Be sure that switch is in off position 0 and
connect the machine to a suitable socket.
•Place the machine near the pool keeping safety
distance of 2 mt from the border.
• The machine must be always kept on horizontal
bases, in a safe and stable way.
• The machine can be used without wheels if not
in a perfectly stable position.
• Place the drainpipe (C) in the correct direction
10
0: machine switched off
1:
manual operation (wet
& dry
vacuum cleaner
function)
2:
operation
(pool cleaner function)
fig. ①