Before First Use; Intended Use; Operation; Accessories - Batavia BT-CRW001 Manual De Usuario

English
• The dust produced when using this tool
may be harmful to health. Do not inhale
the dust. Wear a suitable dust protec-
tion mask.
• Do not work with any materials that
present a danger to health (e.g.
asbestos)
• Switch the device off immediately if the
insertion tool stalls! Do not switch the
device on again while the insertion tool
is stalled, as doing so could trigger a
sudden recoil with a high reactive force.
Determine why the insertion tool stalled
and rectify this, paying heed to the
safety instructions. The possible
causes may be:
— it is tilted in the workpiece to be
machined
— it has pierced through the material
to be machined
— the power tool is overloaded
• Do not reach into the machine while it is
running.
• When working in walls ceiling, or floor,
take care to avoid electric cables and
gas or waterpipes.
• Clamp your workpiece with a clamping
device. Unclamped workpieces can
cause severe injury and damage.

3. Before first use

Remove any packing material and loose
parts from unit. Check the accessories
before use. It should be fit with the machine
and your purpose. If the machine is new, the
battery must first be charged.
Attention!
After long time storage, the battery capacity
will be reduce. Battery is housed in the han-
dle, press the battery retention clips, and
remove battery from handle. A substantial
drop in operating period per charge indi-
cates that the battery is worn out and must
be replaced.

4. Intended use

The ratchet wrench is intended to be used
only by adults who have read and under-
stood the instructions and warnings in this
manual, and can be considered responsible
6
for their actions. The product is intended for
fastening and removing screws and bolts
using an impact socket. The product is
intended for consumer use only. Do not use
the product for any other purpose. Use of
the product for operations different from
intended could result in a hazardous
situation.

5. Operation

On/Off Trigger
5.1
• Use the On/Off trigger (4) to start the
machine and keep holding it for contin-
uous operation.
• The rotation speed can be varied by
depressing the On/Off trigger. The more
the trigger is pressed, the faster the
rotation speed.
• To switch the machine off, release the
On/Off trigger
Reverse-rotation Lever
5.2
Important! The machine has to come to a
complete stop before the reverse rotation
lever can be used; otherwise the machine
may be damaged.
Use the reverse-rotation lever (1) to switch
between clockwise (normal) and anticlock-
wise rotation or vice-versa. With the
reverse-rotation lever in the central position
the trigger switch is locked and cannot be
depressed. Put the reverse-rotation lever in
the central position before you put the
machine down, to avoid unintentional
starting.
LED work light
5.3
The LED work light (3) will be lit automati-
cally as soon as you press the ON/OFF
trigger (4).

6. Accessories

Use only accessories with an allowable
speed matching at least the highest no-load
speed of the tool.

7. Maintenance and Cleaning

WARNING: Always disconnect from the
mains power supply, before carrying out any
maintenance/ cleaning of the charger.
Remove the battery before carrying out any
maintenance/cleaning of the tool.