Parts And Components; Product Installation; Before Use - cecotec BOLERO DRESSCODE 7200 Manual De Instrucciones

ENGLISH

1. PARTS AND COMPONENTS

Fig. 1.
1. Top cover
2. Control panel
3. Power cord
4. Drum
5. Service filter
6. Drain hose
7. Door
8. Detergent dispenser
9. Water supply hose
Attachments
Fig. 2.
1. Transport hole plug
2. Cold water supply hose
3. Hot water supply hose (optional)
4. Drain hose support (optional)
5. Instruction manual

2. BEFORE USE

- Unpack the appliance and keep the original packaging and materials in a safe place.
It will help prevent any damage if the product needs to be transported in the future. In
case the original packaging is disposed of, make sure all packaging materials are recycled
accordingly.
- Make sure all parts and accessories are present and in good conditions. If not, contact
immediately the Technical Support Service of Cecotec.
- Keep all packaging materials away from children.
Note
- Before using the wash machine, the product shall be calibrated.
- Before washing the clothes for the first time, the product shall be operated in one round of
the whole procedures without the clothes inside.
- Make sure that all pockets are emptied. Sharp and rigid items such as coins, brooches,
nails, screws or stones may cause serious damage to the machine.
62

3. PRODUCT INSTALLATION

1. Place the device on a flat, stable and dry surface. Make sure the product does not stand
on the power cord.
Fig. 3.
- Avoid direct sunlight and ensure sufficient ventilation.
Fig. 4.
2. Remove the cardboard box and Styrofoam packing.
3. Lift the washing machine and remove the base packing. Make sure the small triangle foam
is removed with the bottom one together. If not, lay the unit down with on the side surface,
then remove the small foam from the unit bottom manually.
Fig. 5.
4. Remove the tape securing the power supply cord and drain hose.
5. Remove the inlet hose from the drum.
Removing the transport bolts
- The transport bolts must be removed from the backside of the device before using it.
- The transport bolts will be necessary again when moving the product, so make sure they
are kept in a safe place.
In order to remove the bolts:
Fig. 6.
1. Loosen 4 bolts with a spanner and then remove them.
2. Stop the holes with transport hole plugs.
3. Keep the transport bolts properly for future use.
Levelling the washing machine
Warning
The lock nuts on all four feet must be screwed tightly against the housing.
1. Check if the legs are closely attached to the cabinet. If not, please turn them to their original
position and tighten the nuts.
2. Loosen the lock nut to turn the feet until it closely contacts with the floor.
3. Adjust the legs and lock them with a spanner. Make sure the machine is steady.
Fig. 7.
Water supply hose connection
Warning
Do not kink, crush, modify or sever the water inlet hose.
BOLERO DRESSCODE 7200 / 7200 STEEL / 8200 / 8200 STEEL
ENGLISH
63