Hach NT3100sc Manual Del Usuario página 11

Figure 6 Connect the probe to the controller
Section 4 Startup
Connect the power cord to an electrical outlet with protective earth ground or set the circuit breaker
for the controller to on.
Section 5 Operation
5.1 User navigation
Note: Refer to the controller User Manual for keypad description and navigation information.
5.2 Configure the probe
Enter identification information, configure the measurement and change options for probe settings,
data handling and storage.
1. Make sure that the controller has the latest software installed. Refer to the controller user manual
for more information.
2. Go to the device menu as follows:
• SC200 and SC1000 Controllers—Go to the main menu, then select Sensor setup. If
applicable, select the sensor.
• SC4500 Controller and Claros interface—Select the tile of the device, then select Device
menu.
3. Select Configuration.
4. Select an option.
Option
Edit name
Description
Enters a description for the measurement site (default: serial number). Use the
description to identify the measurement locations (e.g., Areation tank 1). The
description is saved with the measurement values in the controller data log.
English 11