Tabla de contenido
Idiomas disponibles
Idiomas disponibles
6.3.2 Set Temperature
When heat pump is on, short-press
in area
temperature value twinkles, press
and exit current setting. No any set up after 30 seconds, the controller will save the last setting
and go back to original surface.
6.3.3 Set Parameter
When heat pump is on, Long-press
or
select among Parameter Query/Parameter Setting/Debugging Status/History Fault.
Short-press
to confirm your selection and switch to
displays the value.
When on status of Parameter Setting,
enter your password, press
right,
displays Parameter No.
When on status of Debugging,
testing mode, and
into testing mode.
6.3.4 Display on each status:
Parameter Query
Note: Value twinkles, means it is available for changing, or in verse
6.4 Function Diagnosis
When Heat Pump is off, Dial 4 switches to 1, give the heat pump power into status of function
diagnosis automatically. Then display will show each symbol and change every 1 second.
or
into menu,
and
displays the Number, 01 water pump debugging, 02
displays ON or Off. The related mode symbol twinkles after entering
Parameter Setting
into water temperature setting surface. Water
or
to select value, press
displays Parameter Query, press
, press
and
display two"88", it is asking you to
to select,
to confirm. When password is
press
displays related parameter value.
Debugging Status
15
to confirm
or
to select,
Error Query
V.1
Tabla de contenido
