Iberspa SW11487 Manual De Uso E Instalación página 40

HEAT MODE - READY vs REST | TOUCH PANEL
In order for the spa to heat, a pump needs to circulate water through the heater. The
pump that performs this function is known as the "heater pump".
The heater pump can be either a 2-speed pump (Pump 1) or a circulation pump.
does not occur, the temperature display may not show a current temperature until
the heater pump has been running for a minute or two.
CIRCULATION MODE | TOUCH PANEL
continuously. Since the heater pump is always running, the spa will maintain set
temperature and heat as needed in Ready Mode, without polling.
mode.
READY-IN-REST MODE | TOUCH PANEL
Ready in Rest Mode appears in the display if the spa is in Rest Mode and the Jets 1
Button is pressed. The spa is supposed to be in use and it will be heated up to the
be working untill the temperature selected is reached or when one hour has passed
by. After that, the System will revert to Rest Mode. This mode can also be reset by
selecting the Heat Mode line on the Screen shown here.
FILTRATION | TOUCH PANEL
Using the same adjustment as Setting the Time, Filter Cycles are set using a start
time and a duration. Each setting can be adjusted in 15-minute increments. The panel
calculates the end time and displays it automatically.
The Filter Icon on the Settings Screen takes you to a screen where you control
the Filter Cycles.
Filter Cycle 2 is OFF by default. Press "1" to view Filter 1. Press "2" once to view Filter 2.
Press "2" again to turn Filter 2 ON or OFF. When Filter Cycle 2 is ON, it can be adjusted
in the same manner as Filter Cycle 1. It is possible to overlap Filter Cycle 1 and Filter
In order to maintain sanitary conditions, as well as protect against freezing, secondary
water devices
If the Filter Cycle 1 duration is set for 24 hours, enabling Filter Cycle 2 will initiate a
purge when Filter Cycle 2 is programmed to begin.
40