Main Screen - Iberspa SW11487 Manual De Uso E Instalación

CONTROL SYSTEM FOR Touch panel
Fill the spa to its correct operating level. Be sure to open all valves and jets in the plumbing
After turning the power on at the main power panel, the top-side panel will display a
splash screen or startup screen.

MAIN SCREEN

| TOUCH PANEL
1 2 3 4 5
9
10
11
1. H = High Temperature Range.
2. R = Ready Mode.
3. F1= Filter1 Mode.
4. O3=Water Care (Ozone or UV, depending the system installed) is Running.
If you don't see the icon that means the Disinfection (Ozone or UV) is OFF
5. C= Cleanup Cycle is Running.
Note: Not all systems that can run a Cleanup Cycle display this icon.
6. = Wi-Fi icon just indicates that the Wi-Fi link is connected. It does not indicate
signal strength.
Note: Not all systems that support Wi-Fi display this icon.
7. Lock Icon: When displayed, indicates the panel is in a locked mode. To unlock or
then press the word "Lock" for 5+ seconds until the text and icon change to the
opposite state.
There are 2 lock icons that can be shown on the title bar of most screens.
A tall skinny one
the Panel being locked. If both settings and panel are locked, only the panel lock
6 7 8
12
13
14
15
16
17
18
L = Low Temperature Range.
RR= Ready And Rest Mode. |R= Rest Mode.
F2 = Filter2 Mode. F+ = Filter 1 and 2 Mode.
representing a settings lock is applied. It is shown on screens that
025
ENG
which represents
37