Husqvarna TS 146XK Manual De Usuario página 20

15. Turn the ignition key to the STOP position to stop the
engine.
16. Stop the water supply.
17. Pull back the lock collar of the nozzle adapter
and disconnect the nozzle adapter from the deck
washout port.
18. Move the product to a dry area.
19. Engage the cutting deck and let it operate until the
cutting deck is dry.
To adjust the throttle control cable
The throttle control is set at the factory and adjustment
should not be necessary. If an adjustment is necessary,
see the Engine manual.
To examine the interlocks and the relays
Note:
Loose or damaged wires can make your
product run unsatisfactorily, stop running or prevent it
from starting.
• Examine the wires.
To replace the LED headlight
1. Lift the hood.
2. Disconnect the harness from the LED light.
3. Remove mounting screws to remove the LED light,
reflector and lens.
4. Replace the LED light, reflector, or lens correctly.
5. Install with the mounting screws.
6. Reconnect the harness to LED light.
7. Close the hood.
To do a check of the tires
Note:
To seal the tire holes and prevent flat tires
because of slow leaks, purchase sealant from your local
parts dealer. Tire sealant also prevents tire dry rot and
corrosion.
• Make sure the air pressure in all tires is correct (See
the sides of tires for correct PSI).
• Keep the tires free of gasoline, oil or insect control
chemicals that can cause damage to the rubber.
• Keep the tires away from stumps, stones, rut pits,
sharp objects and other dangerous objects that may
cause tire damage.
To repair the tires
1. Lift the front axle and support it safely.
CAUTION:
at a time.
20
Lift and support one axle
2. Remove the dust cover (A), the E-clip (B), the
washer (C) and the square key (D).
C
B
A
D
Note:
There are square keys on the rear wheels
only.
3. Remove the wheel from the axle.
4. Remove the tire from the wheel.
5. Repair the tire.
Note:
Use tire sealant to seal holes in the tire. Tire
sealant also prevents tire dry rot and corrosion.
6. Install the tire on the wheel.
7. Install the wheel, the washer, the square key, and
the E-clip on the axle. Make sure that the E-clip is
installed correctly in the groove on the axle.
8. Install the dust cover.
To examine the V-belts
The belts are not adjustable.
• Examine the V-belts for deterioration and wear after
each interval of 100 hours of operation.
• Replace the V-belts if they start to move because
they are too worn.
To do maintenance on the transaxle cooling
fan
CAUTION:
transmission while the engine is on or while
the transmission is hot.
CAUTION:
washer or a steam cleaner. Water can go
into bearings and electrical connections and
cause corrosion which causes damage to
the product.
To keep the transmission cool, keep the transmission
fan and cooling fins clean.
Do not clean the fan or the
Do not use a high-pressure
1939 - 003 - 25.08.2022