Yuasa YCXLI2 Guia Del Usuario página 5

WET
AGM
GEL
Li
Selecting the correct charging rate
To select the correct charge rate, consult the Ah rating displayed on the
label of the battery.
Find this Ah rating in the table below and use the AMP button on the
charger to select the suggested charge rate. Where two charge rates are
available, the higher option will result in a faster charge time.
Charge rate
Charging
Maintenance
Selecting power supply mode
Power supply mode is designed for recovery of overdischarged batteries
which would be too low for the smart charger function to recognise. We do
not recommend using power supply mode for any other application.
• Do not use as a stand-alone power supply for other 12V devices.
• Do not use as a vehicle memory maintainer (risk of damage to
pyrotechnic components and vehicle damage).
Press and hold the MODE button for three seconds to select power supply
mode. When selected, press and hold the MODE button for three seconds
again to turn off power supply mode.
After selecting power supply mode, do not allow reverse polarity connection
to battery terminals as it will cause permanent damage to the charger.
LED charging indicators
Fast flash = 0.2S ON and 0.2S OFF
Blinking = 0.2S ON and 1.8S OFF
Flashing = 0.5S ON and 0.5S OFF
LED
Double blinking in
One bar flashing
Two bars flashing
Three bars flashing
Four bars flashing
MF, SMF, EFB, CaCa, CaSb, SbSb
AGM
GEL
Lithium-ion, LifePO4
2A
6-40Ah
Up to 120Ah
ON
Status
sequence
Blinking in
sequence
YCXL12
8A
24-160Ah
Up to 240Ah
Power supply mode selected
Descriptions
Battery condition check
Rejuvenation phase
Soft start phase
Bulk charge (less than 13V) phase
Bulk charge (above 13V) phase
Absorption or repair phase
12A
36-240Ah
Up to 360Ah
5