Yuasa YCX1.5 Guia Del Usuario página 4

has been selected.
Connecting the charger to your battery
If the battery is out of the vehicle:
Connect the red lead from the charger to the positive (+) battery terminal.
Connect the black lead from the charger to the negative (-) battery terminal.
If battery is in the vehicle:
The below is a guide, please consult your vehicle's owner manual for information
and procedures on your specific vehicle.
Determine if the vehicle is positively or negatively earthed.
If negatively earthed (most common) - First connect the red lead from the charger
to the positive (+) battery terminal and then connect the black lead from the charger
to the vehicle's chassis and far away from the fuel line.
If positively earthed - First connect the black lead from the charger to the negative
(-) battery terminal and then connect the red lead from the charger to the vehicle's
chassis and far away from the fuel line.
Connect the battery charger to mains power
The charger will automatically start when mains power is connected and switched
on.
(Note: If the LED fault indicator illuminates red, please check your connections as it
is likely that the positive and negative leads are reversed. Refer to Troubleshooting
for further information).
Disconnecting the battery charger from the battery
If the battery is out of the vehicle:
Switch OFF and remove the mains power socket from the outlet and wait for a
minimum of five minutes before disconnecting the charging leads.
Remove the black lead followed by the red lead.
Check electrolyte levels if possible. They may need topping up with distilled water
after charging.
If the battery is in the vehicle:
Switch OFF and remove the mains power socket from the outlet and wait for a
minimum of five minutes before disconnecting the charging leads.
Remove the lead from the vehicle chassis.
Remove the lead from the battery.
Check electrolyte levels if possible. They may need topping up with distilled water
after charging.
4