Idiomas disponibles
Idiomas disponibles
ting accessory and cause loss of control or kickback.
5) Do not attach a saw chain woodcarving discs
or toothed saw discs. Such discs create frequent
kickback and loss of control. 6) Do not use exces-
sively oversized discs. Follow the recommendations
of Werku
, when selecting discs. Larger discs exten-
®
ding beyond the base disc present a laceration ha-
zard and may cause snagging, tearing of the disc or
kickback.
DESCRIPTION OF THE PRODUCT.
This sander-polisher is suitable for lime-cement
and gypsum-based surfaces, for sgraffito purpo-
ses and for smoothening insulating boards in the
case of full heat protection.Refer to this plan to fa-
miliarize yourself with this sander-polisher before
use.
E
A
B
I
L
A. Base disc 370 mm.
B. Sponge disc 390 mm (for smoothening lime-
cement-based plasters).
C. Smoothening disc 377 mm (for smoothening lime-
cement and gypsum-based plaster).
D. Plaster plane disc 370 mm (for smoothening lime-
cement based plasters).
C
D
J
K
H
F
G
English
E. Sanding disc 370 mm (for smoothening insulating
boards in the case of full heat protection).
F. Switch.
G. Base disc.
H. Handle.
I. Auxiliary handle.
J. Carbon brushes access.
K. Lock-on button.
L. Speed control.
USE INSTRUCTIONS.
Before starting up this sander-polisher, we recom-
mend that you carefully read all of the instruc-
tions as indicated. Please respect all regulations
regarding the prevention of accidents, health and
safety directives, laws and applicable restrictions
for work places. This sander-polisher must only
be used by persons who have been instructed in
its use and only for the purposes for which it has
been designed.
POWER SUPPLY.
Make sure the power supply is adapted to the re-
quirements shown on the information panel of this
sander-polisher (1). Using the motor at low volta-
ge will make it operate slowly. This will reduce per-
formance and may cause the motor to overheat.
EXTENSION CORD.
If the working area is at some distance from the
power supply, use an extension cord of enough
diameter and quality.
IMPORTANT.
This sander-polisher must be held by both hands
to achieve the best possible position for using this
sander-polisher in any application.
SPEED SELECTOR.
This sander-polisher is equipped with a speed se-
lector (2). The slowest speed is in position "1" and
the fastest on "6". The optimum speed adjustment
for each application mainly depends on the user's
preferences. In general, a high value is preferable
for hard materials and a lower value for soft ma-
terials. The speed at which material is removed
increases with the spin speed.
LOCK-ON BUTTON.
This sander-polisher is fitted with a blockade but-
ton system. For it press the switch and then press
the blockade button (3). Just by to return to press
5
