4.4 Use charger correctly
•
Charger only uses on rechargeable battery. If not, it can cause fire or explode. Use original charger to
keep safety.
•
Always check charger, the wireand plug before use. If damaged, please move to Customer Assistance
Service to repair.
•
Do not use damaged charger, do not repair by yourself, this will keep the tool safe.
•
Check voltage of charger match the battery value, if not may injury yourself.
•
Keep charger clean, away from drippy or rain environment. Do not use the charger outdoor, dirt or
water can cause injury.
•
The charger is designed for original battery only. Otherwise, may be cause damage or fire.
•
Avoid damaged charger will reduce injury.
•
Do not use chargers on tinder surface (e.g.,paperor dry goods).
5
The battery is not fully charged when you buy it, you must charge 3/5 hours before first use the tool.
Connect the battery to charger before power on.
6
Normal charging time is 3/5 hours, don't charge the battery for too long time, it will damage the
battery.
7
The charger has three outputs, you can charge up to 3 batteries simultaneously. The charging time
is proportional to the number of batteries connected and the state of their charge. Monitor the
charging time by the LED indicator (red light in charge, green light end of charge).
4.5 Caution (Residual risk)
Keep use the tool carefully avoid risk as below:
•
Cutting or injuries due to sharp edges
•
Long times operate or irrationally use the tool will damage your body.
Warning!
The equipment will bring electromagnetism; it can interfere with some medical device in body. It is
suggested to ask for doctor advise before the usage of the tool at the same time with medical devices.
Warning!
Do not touchthe blade when the battery is mounted on the tool.Keep a minimum distance of 15cm
between the blades and any part of your body.Keep other people at a minimum distance of 1.5m
Warning!
In particular situations of very hard use, the blade and the handle could reach high temperatures. It is
recommended to handle the pruner with care, using protective gloves.
Sound and vibration measurements:
Sound pressure level: < 70 dB(A)
76