Rating Data; Operating Conditions; Working Instructions; Switching On/Off - SUHNER ABRASIVE FHA 4 Documentación Técnica

ty seconds. Vibrating tools must be replaced immediately.

2.2 Rating data

Connection
Maximum speed
Maximum collet chuck
Weight
Vibration EN 60745
Max. wheel diameter
Max. torque
The specified vibration value was measured with a
standardised test method and may differ from the
actual operating value. The specified value can be
used for product comparisons or for an introductory as-
sessment of work breaks.

2.3 Operating conditions

Temperature range during operation: 0 to +50°C
Relative air humidity: 95% at +10°C not condensed
3. handling / Operation

3.1 Working instructions

To achieve an optimum grinding result, move grinding
tool uniformly back and forth with light pressure.
Excessive pressure lessens the working capability of the
hand tool, as well as the life of the grinding tool.
The hand tool is equipped with an mechanical overload
protection.

3.2 Switching ON/OFF

Before switchin on the drive make sure that the lever is
disengaged.
Hold the hand tool firmly. Switch on the drive. At this posi-
tion there is no connection to the drive. With your other
hand push the cord connector guard against the hand
tool. While you are doing this the grinding tool is acceler-
ate to the set speed.
G16
25000min
-1
Ø6mm
0.270kg
9.1m/s , K=1.5m/s
2 2
40mm
0.6Nm
Press and hold down the lever.
erating.
Switch off the drive when you stop working.
The tool still needs time to stop after the tool has been
switched off.
Put down the hand tool so that there can be no danger.
Remove the hand tool from the shaft.

4.1 Preventive maintenance

4.2 Repair

If despite strict observance of the manufacturing and test-
ing method the hand tool should happen to fail, it must be
repaired by an authorized SUHNER agency.

4.3 Warranty

In the event of the tool being improperly handled, used
for purposes for which it is not intended and/or of the ser-
vice and maintenance instructions not being observed by
non-authorized persons, no warranty shall be in effect for
damages/consequential damages.
Complaints can only be honored if the hand tool is re-
turned in the undisassembled condition.

4.4 Storage

Temperature range during operation: -15°C to +50°C
Max. relative air humidity: 90% at +30°C, 65% at +50°C.

4.5 Disposal / Environmental compatibility

This hand tool consists of materials which can be dis-
Conduct the test run without load for at least thirty
seconds. Do not use vibrating grinding tools.
You must always hold the hand tool when it is op-

4. Service / Maintenance

Always keep the hand tool clean and in a dry
place.
Worn chucks must be replaced.
21