Function Buttons; Displayed Messages; Cleaning And Maintenance - Steinberg Systems SBS-PT-300S Manual De Instrucciones

2. Place an object on the scale.
3. Wait until the reading on the display stabilizes.
4. When weighing is complete, press and hold the ON/OFF button to turn the
product off.
3.3.3.
TARE - Tare. Use this function to weigh the contents of a container.
1. Place the container on the scale.
2. Press TARE button. The display should show "0".
3. Add the contents to be weighed to the container.
UNIT - change the weighing unit (press the button to change the weighing unit).
3.3.4.
"O_Ld": overloaded
"LO": batteries low
"Err": the calibration was not successful
3.3.5.
1. Turn on the scale.
2. Hold down the "UNIT" button until the display shows the maximum load and
then the calibration weight.
3. Press the "TARE" button to select the calibration weight from 10, 20 or 50 kg.
4. Press the "UNIT" button to confirm the selection. The display will show "CAL"
and the selected value will flash.
5. Place an object with the displayed (selected) weight on the scale. If the item is
misaligned or the calibration is aborted unexpectedly, the display will show "Err"
which indicates an incorrect calibration.
6. Press the ON/OFF button to return to normal operation mode.

3.4. Cleaning and maintenance

a) Store the unit in a dry and cool place protected from moisture and direct
sunlight.
b) Do not spray the unit with a stream of water or immerse it in water.
c) Perform regular inspections of the unit checking technical fitness and any
damages.
d) Do not leave the batteries in the device when it will not be used for a long time.
e) Use a soft, damp cloth for cleaning.

FUNCTION BUTTONS:

DISPLAYED MESSAGES:

CALIBRATION: