Programming Memory Dial Buttons - ClearSounds CSC 600 Manual Del Usuario

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

potentially result from misuse.

using the volume reset override

In standard mode, the phone will reset to normal sound levels when you hang

up. This allows people who do not require the level of amplification offered

on the phone to use it. If you would like to override the reset, simply turn the

AUTO AMPLIFY

switch on the back of the phone to "ON" using the tip of a



pencil or paper clip

IMPORTANT: When the AUTO AMPLIFY

switch is in the "oN" position, you do



not need to press the "AMP" (amplify) button. Your amplification setting will

remain as set. on any call, you can temporarily turn OFF and turn back ON the

AUTO AMPLIFY feature by pressing the "AMP" button. If you do not utilize the

Reset override feature you will need to press the AMP button to manually turn

on the amplification during calls.

NoTE: When the amplifier turns on, the red indicator lamp near the AMP button

will be lit. The AUTO AMPLIFY

switch will be pre-set to the OFF position at



the factory

using your CSC600 amplified phone with hearing aids

Your CSC600 phone can be used with hearing aids equipped with a

telecoil (T-coil). Adjust your hearing aid "T-switch" to the "T" position.

Make sure to hold the handset close to your hearing aid.

using the outgoing Speech Volume

You can adjust the sending volume (outgoing volume up to 12 dB

of gain) by using the Speech Volume Control located on the right

side of your CSC600 phone. If your voice is faint or weak, adjust the

volume to "HI". You can also decrease the volume as well. There are

three levels available "Lo, NoRMAL & HI".