Ingco PLM5002 Manual Del Usuario página 9

3) CUTTING DEPTH ADJUSTMENT
Loosen the lock handle, and then push the rubber roller
slightly to the desired depth. Make sure that tighten the
lock handle after each adjustment
4 ) SWITCHING ON AND OFF
△WARNING: To reduce the risk of injury, to make sure you
can control the switch freely and keep it off before plugging the
trimmer. To switch on, turn ii at "1 "position, and to switch
off, push it at "O" position.
5) EDGE TRIMMER
(1) Place the base plate on the work piece ensuring that milling cutter is not in contact
with the material to be cut.
(2) Connect the trimmer to the power supply. And
then turn it on .Ensure you have a firm grip on
both handles. Wait for milling cutter to attain
full speed.
(3) Lower the trimmer and mope it move the work
piece surface, keeping the base plate flush and
advancing smoothly until cutting is complete.
(4) Keep the cutting pressure constant, taking care motor to slow excessively.
(5) To turn the trimmer off, release the switch.
△WARNING: Always use two hands to hold the trimmer, Where possible, clamp the work piece
to the bench.
APPLICATIONS
△WARNING: To reduce the risk of injury, never touch the milling cutter to clean the debris until
it has already stopped and cooled down
1, APPLICATION HINTS
1) When cutting flat panels such as kitchen work surfaces, before joining please ensure that you
use an appropriate jig together with the corret guide bush, DO NOT use the curved part of
the trimmer
2) Always apply pressure in line with the cutter. Use enough pressure to keep cutting, but do not
push hard enough to stall the motor.
9|English