Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3. USING THE CENTRE LOCALIZER
1) Assembly the straight guide with extension
guide as follow.
2) Mark the center point of the circle on the work piece, and align the center hole
with the cut center point, and then fix a screw(diameter less than 6mm)into it to
keep them stable.
3) Adjust the cutting diameter by adjusting the
connection and direction of straight guide and
extension guide.
■Cutting radius:80~217mm as below.
■Cutting radius:103~221 mm as below.
4)
Hold the trimmer closely to operate the trimmer
in a circle as defined by the screw as below.
4. USING THE BASE GUIIDE
1) Loosen the clip knob A to install the hale guide
on the base plate of the trimmer.
2)
Loosen the clip knob B and adjusting knob to
get the desired distance between the base guide
and milling cutter.
11|English
Tabla de contenido
