Securing The Refrigerator - Furrion FCR16DCASA-BG Manual De Usuario

Circuit Wiring Based on Voltage Drop:
Circuit wiring, gauge (AWG), length, and routing is to be
determined by the installer. It must not exceed a voltage drop
at the appliance of more than 4V DC.
To Measure:
Start the appliance from warm, isolate and measure the
voltage difference between each DC12V power source(s)
and the appliance connection. If the Voltage drop exceeds
.4V DC, the length of wire should be shortened, and/or Wire
gauge (AWG) increased.
Circuit Rating: Min 20Amp, Max 40Amp. Do not share
circuit with any other utilization equipment.
NOTE: The circuit must be fused appropriately for the wire
gauge (AWG) used, within 18" of the DC 12V power source.
Only a single blow fuse or manual resettable breaker is
allowed, auto-resetting breakers must not be used. Do not
add an additional fuse to the pigtail end of the appliance.
The following is a starting guideline for wire sizing and should
be adjusted based on actual voltage drop:
● 15ft or less = 10AWG
● 15ft to 25ft = 8AWG
● 25ft to 40ft = 6AWG
Installation TIPS:
● Voltage drop can be reduced by terminating the -12V
(white) lead directly to the vehicle chassis.
● -12V (white) and Ground (Green) leads can be combined
at the appliance or individually terminated.
Ground (Green)
-12V ( )
● Enter supply wire into the cabinet space. It is acceptable
to enter through the cabinet floor, sidewall, backwall or
ceiling. Ensure that the wire enters within the free cabinet
space behind the refrigerator.
● Furrion recommends dropping the 12V supply wire from
the upper ceiling or upper rear wall. Temporarily affix the
wires to the upper half of the appliance with tape so that
excess wire will droop without risk of rubbing with the
appliance chassis and floor during installation.
Drainage Preparation
The cavity condensate drainage is captured in a drain pan
integrated with the unit. No external drainage needs to be
prepared at this point.

Securing the Refrigerator

● The appliance contains hidden refrigerant lines and
electrical wiring.
Follow all guidance in this section to prevent death, injury
or property damage.
For mobile applications, it is imperative to determine a
sufficient securing method to prevent sliding and tipping of
the appliance during transportation. Furrion is not providing
sufficient mounting methods, but providing guidelines to
consider when evaluating.
Body Mounting
DO NOT pierce screws into any surface of the refrigerator
as there is a risk of refrigeration leak or electrical shock
hazard.
It is acceptable to use brackets to mount to the body's front
frame of the fridge and the floor to hold the fridge in place.
Supply Wire
Not Provided
Pigtail Harness
from Refrigerator
- 6 -
WARNING
FIRE AND ELECTRICAL SHOCK HAZARD
WARNING
FIRE AND ELECTRICAL SHOCK HAZARD
CCD-0005509 Rev: 03-08-22