System Specifications - 110 Vac And 220 Vac Wiring; 220 Vac Basic System Wiring; Important - Pentair INTELLICHLOR IC15 Guía De Instalación Y Usuario

30
System Specifications - 110 VAC and 230 VAC Wiring
Circuit Protection: Two-pole 20 AMP device at the electrical panel.
IntelliChlor SCG Model IC20, IC40 and IC60
Input: 95-130 VAC, 50/60 Hz, 220 Watts (2 AMP) or 220-240 VAC, 50/60 Hz, 220 Watts (1 AMP).
Output: 22-39 VDC @ 7.5 AMPS maximum from the Power Center.
Note: A TIME CLOCK must be used if the IntelliChlor SCG is used in "stand alone" mode without an
automation control system.
IntelliChlor (SCG) AC Wiring Instructions:
SCG and an IntelliFlo pump (or 2-speed pump) with an IntelliTouch
®
EasyTouch or SunTouch
center wires must be connected to the LOAD SIDE OF THE MAIN FILTER PUMP
RELAY located in the load/power center (see page 27 for diagram). This
ensures that the IntelliChlor SCG cell produces chlorine only when the main
filter pump is on. This method does not require a ground fault circuit-interrupter
(GFCI) to protect the circuit.
IMPORTANT: When using IntelliChlor SCG with an IntelliTouch Control System, it is
recommended to wire the Power Center to the pump side of the relay located in the IntelliTouch
Control System Load Center. This method does not require a ground fault circuit-interrupter
(GFCI) to protect the circuit.
®
IntelliChlor Salt Chlorine Generator Installation and User's Guide
®
Control System, the IntelliChlor SCG AC power
115 VAC Basic System Wiring with Pool Pump Timer
When using the IntelliChlor
®
,