gs yuasa yuasa YCXL12 Guia Del Usuario página 10

Troubleshooting
Types of Indication
problems
Charger No indicator
does not lights on.
work
Charger has LED fault
no DC output indicator is ON.
No charging LED fault
current indicator is ON
and charging
percentage LED
bar flashing or
blinking in
sequence.
No charging LED fault
current indicator is fast
flashing.
Full / float LED fault
light won't indicator is
come on flashing. The
or full LED charging
flashing percentage LED
bar is flashing or
ON.
Possible Suggested solution
causes
No mains power. Check mains connections and
make sure power is switched
ON
Output is short Check DC connection between
circuited. charger and battery and make
sure they are not short circuited.
Reverse polarity
connection to Check that the crocodile clips
battery. haven't fallen off the battery.
Check that the crocodile clips /
eyelets are connected to the
correct polarity.
Battery is Check the battery condition, age
severely etc.
sulphated.
Battery may need replacement.
Battery has a
damaged cell. Check the battery capacity.
Overheat Move battery and charger to
protection mode. cooler environment.
Check the battery charger.
Battery capacity Check the charger specification
too large for the matches the battery capacity.
battery charge
setting and it has Battery cannot be charged and
timed out or must be replaced.
battery is slightly
sulphated. Charge rate selected might be
too low. Switch charger off and
on and try a higher charge rate
setting, providing it doesn't
exceed the maximum charge
limit for your battery.
10