Pump Saver - BE Power Equipment P1915EN Manual Del Operador

OPERATING INSTRUCTIONS CARE AND MAINTENANCE
Storage
• When your pressure washer session has been
completed, turn off the power switch located on
the front of the power washer. Unplug the power
cord from the outlet. Turn off the water supply.
Pull the trigger on the spray gun 2-3 times to
drain out the excess water and to release any
remaining water pressure. Disconnect the garden
hose adapter from the water inlet. DO NOT allow
the power washer to run with no water flowing
through it.
• Remove high pressure hose from spray gun.
• Remove lance from the gun. Place the gun in the
holster on the side. Lances are placed into any of
the slots in the back of the unit.
• Make sure to discard any remaining detergent
from the bottle. Residual chemical will stick to
the container which could become cotaminated,
and can cause the detergent injector to clog and
not function properly. Flush the bottle and nozzle

PUMP SAVER

Pump Saver is a product that protects and prolongs
the life of the pump. This will keep the internal parts
of the pump lubricated and protected from freezing
while being stored in ALL climates. It also assists with
protection from internal corrosion. The BE Power
Equipment part number is: 85.490.046. Purchase at a
BE Power Equipment retailer near you.
Pump Saver Instructions
Follow the previous storage instructions for your
power washer. To prevent staining, protect the surface
under the power washer from any excess fluid. Wear
eye protection when using this product.
Turn unit off and disconnect the gun before adding
pump protector. Unscrew threaded top from bottle to
remove seal and reattach threaded top to bottle.
Remove black cap from bottle.
1) Place top of pump saver bottle onto the garden
hose adapter.
2) Secure pump saver bottle by turning in a clockwise
direction.
bepowerequipment.com
head with fresh water to prevent clogging.
• Hook the power cord around the cord hook on the
right side of the machine when facing it.
• The pressure hose is stored on the hose hook
located on the back of the handle.
• DO NOT store the power washer where it is
exposed to freezing temperatures unless you
use an antifreeze designed for pumps. Store the
power washer indoors to prevent the water in the
unit from expanding under freezing conditions.
When the water freezes and expands, your power
washer will be damaged and become inoperable.
Or, if storing outdoors, it is recommended you use
pump saver (not included) to protect pumps.
3) Turn the power on.
4) Squeeze bottle to help it into the pump.
5) Turn power off when pump saver exits the
machine's water outlet.
Note: Instructions on Pump Saver Bottle are generic
and not model specific.
15