Care And Maintenance - BE Power Equipment P1915EN Manual Del Operador

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

CARE AND MAINTENANCE

OPERATING INSTRUCTIONS
Detergents
• Use detergents designed for power washers.
Hardware stores or home centers also have power
washer detergents for different cleaning projects.
The cleaning solution should be the consistency of
water in order to prevent clogging your detergent
bottle and nozzle.
• This system applies detergent under low pressure.
The cleaning power of the detergents is enhanced
when applied with low pressure and enough
time is given to break down dirt and grime. The
combination of low pressure and chemical action
is very effective and can be better than scrubbing
if applied properly. ALWAYS spray detergent on a
dry surface. DO NOT pre-soak area. Wetting the
surface first dilutes
the detergent and reduces its cleaning ability.
DO NOT allow detergent to dry on surface. On
vertical surfaces being cleaned, apply detergent
to lower surfaces and work your way up to prevent
detergent from causing streaks in the dirt and
grime. Rinse detergent by pressure washing from
bottom up for same reason.
• If a stain is particularly tough, it may be necessary
to reapply the detergent and use a bristled brush
to scrub the stain. Subsequent power washing
after brushing should successfully complete your
cleaning job.
Cleaning Garden Hose Adapter
• The screen inside the adapter should be cleaned
periodically. Remove it by dragging a thumb over
the screen with enough pressure to pull the screen
and washer out. Rinse it with clean water and then
place it back in the adapter.
14
Cleaning Nozzles
• A clogged or partially clogged nozzle can cause
significant reduction of water pressure coming out
of the nozzle and/or cause the unit to pulsate while
spraying.
• Turn off the unit.
• Turn off the water supply to the unit.
• Relieve any pressure trapped in the hose by
squeezing the trigger 2-3 times, and then lock the
spray gun.
• Using the nozzle tip cleaner provided (or an
unfolded paper clip), insert the wire into the nozzle
hole and move back and forth until debris is
dislodged.
• Back flush water through the nozzles using garden
hose and highest pressure available (either
standard water nozzle or use your thumb over the
nozzle to create water pressure for back flush).
bepowerequipment.com
Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

96395-lj

Tabla de contenido