Transport And Storage; Troubleshooting - Wolf Garten Lycos 40/300 T Manual De Instrucciones

EN

Transport and storage

Risk of injuries due to the cutting tool.
¾ Before transport or storage, switch off
the device and wait until the cutting tool
comes to a standstill.
¾ Remove the power pack before transport
or storage.
¾ Allow the device to cool.
Storage
Thoroughly clean your device after every season.
Î
Always store the device in a dry and safe location
Î
that is inaccessible to children.
Risk of injuries or material damage
¾ In case of doubt always consult a specialist workshop.
¾ Before any inspection or any work on the device, switch off the motor and remove the power
pack.
Problem Possible cause
The device switch- The power pack is too hot.
es
The power pack is discharged.
off.
The temperature of the device (electronics) is
too high.
Overcurrent release
The device will not The power pack is discharged.
switch on.
Overvoltage release
Overcurrent release
Power pack temperature too high or too low.
The power pack is defective.
Automatic line The spool is empty.
adjustment does
The toothing between the line box and the line
not work.
spool is dirty.
The line has torn off and is pulled into the line
spool.
The line has become caught in the spool.
The line is welded onto the spool.
The line breaks off The line comes into contact too frequently with
too frequently. fixed objects, e.g. fences, trees, etc.
Strong vibrations Device fasteners have come loose.
26
WARNING!
Store the power pack and trimmer separately.
Î
Store the power pack in a cool and dry loca-
Î
tion. Recommended storage temperature ap-
prox. 0 - 23°C Keep the trimmer and especially its
plastic components away from brake fluids, petrol,
mineral oil containing products, penetrating oils
etc. They contain chemical substances that can
damage, attack or destroy the plastic components
of the trimmer.
Fertilizers and other garden chemicals contain
Î
substances that may have a highly corrosive
effect on the metal parts of the trimmer. Therefore
do not store your trimmer in the vicinity of these
substances.

Troubleshooting

WARNING!
Remedy
Allow the power pack to cool.
Charge the power pack.
Allow the device to cool and if necessary,
clean the ventilation slots
If this occurs again take your device to a
specialist workshop.
Charge the power pack.
If this occurs again take your device to a
specialist workshop.
If this occurs again take your device to a
specialist workshop.
Allow the power pack to cool down or
heat up.
Replace the power pack.
Replace the line spool.
Use a brush to remove dirt from the parts.
Take off the line spool, if necessary
rewind the line by gently pulling and insert
the spool.
Remove the welded line part, if necessary
rewind the line by gently pulling and insert
the spool.
Use the plant protection bow.
Consult a specialist workshop.
Transport and storage