Assembly - Wolf Garten Lycos 40/300 T Manual De Instrucciones

Assembly

Assembly
Attaching the plant protection bow A B
Pull the plant protection bow Ab somewhat apart
Î
so that it can be attached to the trimmer 1 .
Insert the plant protection bow into the mounting
Î
on the trimmer 2 .
Attaching the protective cover A C
Position the protective cover Aa on the
Î
trimmer 1 .
Screw on the protective cover with the supplied
Î
screws A on 2 .
Note
Only tighten the screws by hand.
Connecting the handle of the trimmer unit to
the operating arm D
Align the handle in such a way that the recess and
Î
the retaining collar are opposite to one another.
Insert the trimmer unit in the holder of the oper-
Î
ating arm 1 .
Fully tighten the fastening sleeve 2 .
Î
Assembling middle handle A E
Position the fitting Ac of the middle handle on
Î
the handle of the operating module 1 from above
between the two adjustment limiters.
Place the middle handle Ad onto the fitting so
Î
that the holes lie on top of one another in a con-
centric manner 2 .
Press the bolts Ag into the holes 3 from the side
Î
with the depression for receiving the bolt head.
Position the washer Ai and the quick release
Î
lever Ae on the bolt from the other side 4 .
Keep the quick release lever aligned with the hole
Î
in the bolt.
Press the nuts Am into the recess of the quick
Î
release lever 5 .
Insert the threaded pin Ah through the quick
Î
release lever and bolts and firmly tighten it 6 .
Attach the middle handle by pushing the quick
Î
release lever downwards 7.
Adjusting the middle handle F
Undo the quick release lever on the middle
Î
handle 1 .
Push the middle handle to the desired height 2 .
Î
Adjust the inclination of the middle handle 3 .
Î
Press the quick release lever into the locked posi-
Î
tion again 4 .
Attaching the carrying belt A G
Attach the carrying belt Af using the two snap
Î
hooks on the hook of the operating module.
Adjusting the carrying belt L
Adjust the carrying belt to the desired length. The
Î
attachment hook should be at hip height.
Note
In order that you have better control over the
device and so that your arms and back do
not tire too quickly, the carrying belt must
always be used with the device.
Note
For safety reasons only carry the device
supported over your shoulder and never
around your neck. The belt has a quick
release attachment so that it can be quickly
disconnected in the event of a malfunction.
Adjusting the working angle H
Risk of injuries due to the cutting tool.
¾ Only adjust the device with the motor
switched off and the cutting tool at a
standstill.
¾ Do not reach into the area of the rotating
line.
¾ Always remove the power pack prior to
working on the device.
The trimmer can be set in any of five different work-
ing angles. This allows you to easily reach problem- atic and difficult-to-access positions in the garden.
Press and hold the locating button 1 .
Î
Set the operating angle 2 .
Î
Release the locating button.
Î
3 The head of the lawn trimmer engages audibly.
WARNING!
EN
23