GET ECULMB Guia De Instalacion página 9

D. ACCESSORIES INSTALLATION
MAP SWITCH INSTALLATION
REMEMBER TO WORK UNDER SAFETY CONDITIONS
AND TO KEEP THE ENGINE TURNED OFF.
1.
Install
Switch to the handlebar.
2.
Connect MAP Switch
faston terminals to the
MAP Switch expansion
cable faston terminals.
3.
Remove the protective
cap and connect the
expansion cable to the
"AUX" connector of the
ECULMB unit.
WIFI-COM INSTALLATION
Install the WiFi-COM by following the dedicated manual.
ATTENTION: After the installation, check that the wiring
does not obstruct the free movement of the handlebar in
both directions or interfere with the moving components
of the motorcycle (e.g., transmission) or with the rider
(e.g., the boot area).
GET Map
EXPANSION
EXPANSION
CABLE
CABLE
9
ECULMB
EN