GET ECULMB Guia De Instalacion página 8

8.
Connect the stepper
motor control connector,
provided in
between
harness and the vehicle's
stepper motor.
9.
Re-install the control unit lid.
ATTENTION: After installing GET control unit, for the
first startup it is mandatory to turn the key of the main
switch into ON position without starting the engine,
and then turning the key into OFF position to switch
off the dashboard. Wait 10 seconds before starting
the engine. This procedure is for resetting the position
of the idle control valve. If this procedure is not carried
out, the vehicle may experience a difficult starting or not
starting at all.
EN
GET kit,
the OEM
8