GET ECULMB Guia De Instalacion página 6

C. GET ECULMB INSTALLATION
1.
Find the OEM control unit in the back of the ATV: check
on the workshop manual where to find it. Remove the
control unit lid. Press the retainer clip of the OEM control
unit connector before pulling it: make sure to unplug the
connector without damaging it.
2.
Remove the OEM
control unit and the
OEM support bracket.
Keep the two OEM
screws, the two OEM
bushings and the two
OEM anti-vibration
grommets which will be
used later on. The OEM
support bracket will not
be used.
3.
Place the two OEM
anti-vibration grommet
into the two side holes
of GET support bracket
included in the kit. Place
the OEM bushings on
GET support bracket and
fix it to the vehicle with
the OEM screws.
EN
6