Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3. Remove the four (4) 1/4" hex-head screws securing the
front bulkhead to the side panels. Lift the bulkhead up off
the side-panel tabs and remove.
A.
1/4" Hex-Head Screws
B.
Side Panel Tabs
4. Reach under the drum, (raise it as far as it will go), and push
the idler pulley arm, on the back of the drive motor, to the
left to relieve the tension on the belt, then remove the belt
from the pulley.
5.
Slide the belt off the front of the drum and remove belt.
6.
Lift the drum and remove it from the dryer cabinet.
IMPORTANT - Note position of drum belt, front and rear
orientation of drum for reassembly.
A.
B.
C.
6
Front Side of Drum
Drum Belt
Rear Side of Drum
Tabla de contenido
