How To Use - SOLAC Siphon Brewer 3-in-1 Instrucciones De Uso

(Original instructions)

HOW TO USE

Before using your coffee machine for the first
•
time make sure you read thoroughly this entire
instructions manual and to clean your applian-
ce according to the directions mentioned on
the cleaning part of "before using for the first
time".
COFFEE MODE
1. Fill up the jar with room temperature drin-
•
king water above the minimum level of
16.9 oz. (0.5 L) but below the maximum level
of 30.43 oz. (0.9 L).
2. Set the siphon tube inside the jar, with the
•
circular part facing up and lining it up along
with the jar gaps, afterwards turn the tube cloc-
kwise until it sets. (Fig. 1)
3. Above the jar, set the upper vessel lining its
•
mark up with the handle's line. Then turn the
upper vessel by its handle, clockwise until both
handles match.
4. Put inside the upper vessel the mesh filter
•
handling it by its insulating handle and make
the flanges of the mesh filter align with the
upper vessel gaps, finally turn the mesh filter
clockwise until it adjust.
5. Put the ground coffee in (maximum quanti-
•
ty 1.76 oz. or 50 g), according the amount of
water with which you filled up the jar and then
close the lid of upper vessel.
6. Place the appliance over the heating plaque
•
then plug to the power source.
ONE COFFEE CYCLE
1. Turn on by pushing the on/off button once, a
•
red light will turn on.
2. Once the water reaches the perfect tempe-
•
rature, in about 5 minutes, the water will raise
through the siphon tube all the way up to the
upper vessel. Few seconds after water raising
ends, the coffee brewer and its red light will au-
tomatically turn off.
3. When the infusion time ends, about 1 more
•
minute, the water will descend down suddenly
to the jar, this means your coffee is ready!
4. Your coffee maker will automatically comple-
•
te the brewing process. This process musn´t
be interrupted, please don´t try to open or di-
sarm your appliance until the complete cycle
have finished.
DOUBLE COFFEE CYCLE
If you push twice the on/off button the coffee
•
machine will perform two coffee cycles. You
can do so whether you would like your coffee
stronger, however you must leave the two cy-
cles to reach the end before you open or mani-
pulate any part of your appliance.
1. Turn on by pushing quickly the on/off button
•
twice. The red led light will start flashing.
2. Once the water reaches the perfect tempe-
•
rature, in about 5 minutes, the water will raise
through the siphon tube all the way up to the
upper vessel, when the infusion time ends,
about 1 more minute, the water will descend
down suddenly to the jar, after that the water
will raise again through the siphon tube.
3. Few seconds after the second water raising
•
ends, the coffee brewer and its red flashing li-
ght will automatically turn off.
4. Your coffee maker will automatically comple-
•
te the brewing process. This process musn´t
be interrupted, please don´t try to open or di-
sarm your appliance until the complete cycle
have finished, that means that the coffee has
already finished its second infusion process
and it is completely down in the glass jar.
5. Once the coffee cycles ends (either 1 or 2)
•
your coffee machine will turn off. Please veri-
fy that the red light is turned off, unplug your
appliance and remove it from the heating pla-
que holding by its handle.
6. Steadily holding the jar by its handle with
•
one hand, turn counter clockwise the upper
vessel holding it by its handle with the other
hand until it releases from the jar.
7. Separate the upper vessel from the jar. To
•
remove the siphon tube use the jar lid and align
the gaps of the lid with the flanges of the siphon
tube (for reference, match the "POUR" line with
the handle´s mark) and firmly press down in
order to match the flanges into the gaps, then
turn counter clockwise until the siphon tube
releases from the jar and raise the lid to take
the tube out. DO NOT REMOVE THE SIPHON
TUBE WITH YOUR BARE HANDS!
EN ES