Moving And Storage; Important; Water Inlet Hoses - Kenmore 110.29727800 Manual De Uso Y Cuidado

Style 2:
1. Hold the top agitator section with one hand. Using the
other hand, rotate the dispenser clockwise until it stops
(approximately 1" [25 mm]). To remove, lift the dispenser
straight up. Using a rocking motion, separate the top and
base of the dispenser. Wash three parts (the base, the
cone-shaped cup, and the top) with a mild detergent and
warm water.
2. Making sure the pointed end of the cone-shaped cup is
pointed toward the base, assemble the three parts by
pressing the top and bottom sections together. For ease of
assembly, reassemble the dispenser with the parts upside
down. If the seal came off while removing the dispenser
from the agitator, install the seal as shown.
C
B
A
3. Reinstall the dispenser by aligning the two locking tabs on
the base of the dispenser with the two small slots on the top
of the agitator. Push the dispenser down until you hear it
snap into place. If you cannot get the locking tabs to snap
into place, check the seal. It must be positioned as shown
in Step 2.
B
C
IMPORTANT: Some models are equipped with a liquid fabric
softener dispenser. To avoid damage to the washer or clothing,
do not wash clothes with the liquid fabric softener dispenser
removed or add detergent or bleach to this dispenser; it is for
liquid fabric softener only.

Water Inlet Hoses

Replace inlet hoses after 5 years of use to reduce the risk of hose
failure. Periodically inspect and replace inlet hoses if bulges,
kinks, cuts, wear, or leaks are found.
When replacing your inlet hoses, mark the date of replacement
on the hose with a permanent marker or in the product record
section of this book.
6
All manuals and user guides at all-guides.com
A. Top
B. Cone-shaped cup
C. Base
D
D. Seal
A
A. Dispenser assembly
B. Locking tab on dispenser base
C. Small slots on agitator
D. Agitator assembly
D

Moving and Storage

Because some water may stay in the hoses, freezing can
damage your washer. If storing or moving your washer during
freezing weather, winterize it.
Winterizing your washer
1. Shut off both water faucets. Disconnect and drain water inlet
hoses. Pour 1 qt (1 L) of R.V.-type antifreeze into the basket.
2. Run washer on a drain and spin setting for about 30 seconds
to mix the antifreeze and remaining water.
3. Unplug washer or disconnect power.
To use washer again
1 . Flush water pipes and hoses. Reconnect water inlet hoses.
Turn on both water faucets.
2. Plug in washer or reconnect power.
3. Run the washer through a complete cycle with 1 cup (250 mL)
of detergent to clean out antifreeze.
Storage, non-use, or vacation care
Operate your washer only when you are at home. If you will be
on vacation or not using your washer for an extended period of
time, you should:
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer. This helps avoid
flooding (due to a water pressure surge) while you are away.