Overload Protection; Battery Charging - M7 DG501 Manual De Instrucciones

WARNING:
!

OVERLOAD PROTECTION

Do not apply too much pressure when
operating this tool. Too much pressure will
cause overload and personal injury. The
grinder will stop quickly when it is overloaded.
To restart the tool:
a. release the switch
b. push the lock-off lever forward and then
squeeze the paddle switch.
CUTTING (FIG.8)
FIG. 8
Using the cutting guard, it is possible to
perform limited cut-off operations on small
stock such as concrete, metal tubes, piping,
or rebar.
WARNING:
!
Using the cutting wheel in a grinding
operation will cause the wheel to crack
and break, resulting in serious personal
injury.
WARNING:
!
The cutting guard must be installed when
using a cutting wheel to provide maximum
protection for the operator.
When using a cutting wheel, hold the tool as
shown, and use only the edge of the wheel.
Work with moderate feed, adapted to the
material being cut. Do not exert side pressure
onto the cutting wheel, tilt or oscillate the tool.
When cutting profiles and square bar, it is
best to start at the smallest cross section.
16
OPERATION
Always follow precautions for kickback. Do
not apply side pressure to cutting wheel to
reduce wheel speed. The tool should always
be used so that sparks are directed away
from user.
The battery is supplied partially charged. To
ensure full capacity of the battery, completely
charge the battery in the battery charger
before.
A fully discharged battery pack will charge
in 50 minutes for DB1850 in a surrounding
temperature between 32° F (0° C) and 104°
F (40° C).
1. Charge the Lithium-Ion battery pack with
the correct charger.
2. Connect the charger to a power supply.
3. Align the raised ribs of the battery pack
with the slot in the charger.
4. Slide the battery pack onto the charger.
5. The charger will communicate with the
battery pack to evaluate the condition of
the battery pack.
6. The POWER BAR LED lights will cycle
from right to left during charging. This is
part of the normal charging operation.
7. After charging is complete, the green
LED on the charger will come on and the
POWER BAR LED lights will go displayed
when the POWER BAR button is pressed
while the battery pack is on the charger.
8. The battery pack will fully charge if left on
the charger, but it will not overcharge.
NOTE: For your convenience, the charger
can operate with most generators and
inverters rated at 300 watts or higher.

BATTERY CHARGING