M7 DG501 Manual De Instrucciones página 13

TO ATTACH THE BATTERY PACK
(FIG.1)
FIG. 1
Attach
1. Make sure that the angle grinder is turned
off.
2. Align the raised rib on the battery pack with
the grooves on the bottom of the tool, and
then attach the battery pack to the angle
grinder.
3. Pull on the battery pack to make sure it is
securely latched to the tool.
TO DETTACH THE BATTERY
PACK (FIG.1)
1. Make sure that the angle grinder is turned
off.
2. Depress the battery-release button located
on the front of the battery pack to release
the battery pack.
3. Pull the battery pack forward to remove it
from the tool.
TO INSTALL/REMOVE THE
GRINDING GUARD (FIG. 2)
ASSEMBLY
Detach
Battery-
Release Button
FIG. 2
Adjusting
Screw
Tabs
This tool is shipped with two types of guards.
A dedicated guard must be used when using
the tool as a grinder or as a cut-off tool.
To Install the Guard:
1. Remove the battery pack and remove any
accessory from the spindle.
2. Open the guard lever to release the guard.
3. Align the tabs on the guard with the slots
in the grinder gear-box collar and lower the
guard until the guard can rotate freely in
the groove in the collar.
4. Rotate the guard to a suitable position
so that the guard is positioned between
the spindle and the operator to provide
maximum operator protection.
5. Lock the guard in place by pulling the
guard lever.
WARNING:
!
Keep the guard between you and the wheel.
Do not direct the guard opening toward your
body.
To Remove the Guard:
1. Remove the battery pack and remove any
accessory from the spindle.
2. Open the guard lever to release the guard.
3. Rotate the guard to the position where the
tabs on the guard align with the slots in the
gear-box collar.
4. Lift the guard straight up and remove it
from the tool.
Guard Lever
13