M7 DG501 Manual De Instrucciones página 15

PADDLE SWITCH OPERATION
(FIG. 5)
FIG. 5
Paddle Switch
The angle grinder/cut-off tool is equipped with
a paddle switch to turn the tool on and off.
1. To turn the tool ON, push the lock-off lever
forward and then squeeze the paddle
switch.
2. To turn it OFF, release the paddle switch
and allow it to return to the OFF position.
Make sure that the tool comes to a
complete stop before laying the tool down.
SPEED ADJUSTING DIAL (FIG. 6)
FIG. 6
Speed Adjusting Dial
The speed adjusting dial has levels 1 through
6.
Before using this tool, turn the speed
adjusting dial to level 1 and then set the
speed adjusting dial to a most suitable level
during the grinding/cutting process.
OPERATION
Lock-Off Lever
GRINDING (FIG. 7)
FIG. 7
WARNING:
!
Sparks are generated when grinding
metal. Make sure that no combustible
material is present or can come in contact
with the flying sparks.
Check the grinding wheels before use.
Discard wheels that have been dropped,
bumped, subjected to extreme changes in
temperature, or have come into contact with
solvents or liquids.
1. Prior to actual use, test the tool by letting it
spin at no load for one minute.
2. Make sure that the workpiece is firmly
clamped in place.
3. Hold the tool securely with both hands.
4. Start the tool.
5. Allow the accessory to reach full speed
before beginning work.
6. For a uniform finish, hold the tool at an
angle of approximately 10° to 15° and
apply constant pressure. Too great an
angle causes concentrated pressure on
small areas, which may gouge or burn the
work surface.
7. Control the pressure and surface contact
between accessory and workpiece.
8. When finished, turn off the tool and make
sure that it comes to a complete stop
before laying it down.
10°– 15°
15