Dometic SMRTSTACR Manual De Instalación Y Funcionamiento página 23

SmartStart RV Soft Start Accessory
7 .3 .4 Connecting the New Supply Wire
Harness
w w
q q
e e
r r
38 Connecting the Wires
Supply Wire Harness
q
Cable Jacket
w
Red Supply Wire
e
Capacitor
r
1. Using the supply wire harness included in the device
installation kit, insert the connection terminals into the
electrical box side opening.
2. Pull the wires into the electrical box until the cable
jacket is at the entrance of the electrical box.
3. Connect the blue supply wire into the relay block in
the electrical box, pressing the connector until it is
fully seated on the relay terminal stud.
4. Connect the red supply wire to the capacitor.
The red fan wire can help identify the correct
I
relay terminal stud location for the red supply
wire.
5. Connect the white supply wire to the open COM
terminal on the capacitor.
6. Gather and secure all the wires inside the electrical
box with a wire tie.
EN
u u
t t
y y
White Supply Wire
t
Wire Tie
y
Blue Supply Wire
u
e e
39 Routing the Supply Wire Harness
Supply Wire Harness Path
q
New Wire Tie
w
7. Route the supply wire harness along the same path as
the existing factory wire harness.
8. Install one new wire tie between the electrical box
and the strain relief to secure the new supply wire
harness to the existing factory wire harness.
q q
q q
q q
q q
w w
40 Securing the Supply Wire Harness with New Wire Ties
New Wire Tie Locations
q
9. Use the remaining three new wire ties to secure the
rest of the new supply wire harness.
10. Replace the electrical box cover and secure it in
place with the two electrical box cover screws.
11. Push the electrical box foam back to its original position.
I The wires on the left side can sit on top of the
electrical box foam if necessary.
Installation
q q
w w
Strain Relief
e
Strain Relief
w
23