Use/Installation Guidelines - Fermax AC-MAX Manual De Instalación

Cod. 970077 V08_19

3.5 Use/installation guidelines

• All electric cables must be connected to devices with disconnected power supply.
• If the range of card reading is significantly lower than specified in technical documentation then
consider relocation of reader.
• After installation of AC-MAX FINGERPRINT reader, remove protector from fingerprint scanner.
Otherwise it may hinder fingerprint scanning.
• In case of connection through Ethernet port, twisted pair cable should be uninsulated in the
shortest possible distance and wires should remain twisted in the longest possible distance.
• It is required to install proximity card readers in minimal distance of 0.5m from each other.
• In order to ensure correct operation of the reader it is necessary to clean fingerprint scanner
regularly by means of wet cloth and mild detergent. Do not clean by means of abrasive materials and
strong cleaners like alcohols, solvents, etc. Damages to scanner surface are beyond the scope of
warranty.
• FPAC-MAX FINGERPRINT reader should be installed in shaded and dry place, far from heat and
moisture. It is necessary to avoid dust and abrupt temperature changes. The reader cannot be installed
in places exposed to direct sunlight. In the event of exposure of the device to direct sunlight or strong
artificial light it may operate improperly.
• Proper finger placing for the purpose of fingerprint reading is shown in fig. 5. In case of kids
(small fingerprints) it is recommended to verify fingerprint reading prior to installation of FPAC-MAX
FINGERPRINT.
All manuals and user guides at all-guides.com
Fig. 5 Proper placing of finger on optical scanner
21/26