Led Indicators; Power Supply; Wall Mounting - Fermax AC-MAX Manual De Instalación

Cod. 970077 V08_19

3.2 LED indicators

FPAC-MAX FINGERPRINT reader is equipped with three LED indicators on its enclosure which
function according to table 3.
Table 3. LED indicators
Symbol Name
STATUS
OPEN
SYSTEM

3.3 Power supply

AC-MAX FINGERPRINT reader requires 12 Vdc supply voltage. The supply must be connected to
+12Vdc terminal and GND terminal. The GND terminal is also reference potential for RS485 bus. All
devices, which are connected to the same RS485 bus should have common ground (GND). In order
to ensure this, all GND terminals of various power supply units in the system must be connected
with each other using separate wire. Alternatively, the common negative pole (GND) of the entire
system can be earthed, but only in single point.

3.4 Wall mounting

All manuals and user guides at all-guides.com
Colour Description
Red/Green Armed/Disarmed mode of reader
Green Door unlocked
Orange Various signalling functions, e.g. microcontroller
memory failure, configuration errors, etc.
FPAC-MAX READER
Fig. 4 FPAC-MAX FINGERPRINT installation
20/26