Configuration; Low Level Configuration (Ac-Max Hw); Configuration Of Communication Parameters - Fermax AC-MAX Manual De Instalación

Cod. 970077 V08_19
4. C
ONFIGURATION

4.1 Low level configuration (AC-MAX HW)

4.1.1 Configuration of communication parameters

FingerPrint communication parameters which concerns Ethernet network and RS485 bus are
configured with AC-MAX HW software. Factory default settings are as follows:
• IP address = 192.168.0.70
• Subnet mask = 255.255.255.0
• Port = 13544
• Communication is encrypted with default (empty) password
Connection and configuration procedure
1. Connect the reader to computer by means of Ethernet port.
2. Configure your computer's network parameters according to FPAC-MAX FINGERPRINT default
settings. The IP address of the computer must be in the same subnet i.e. 192.168.0.xxx.
3. Install and start AC-MAX HW software.
4. In the opened window (fig.6) select FP
Ethernet
communication channel.
5. IP address and port of AC-MAX FINGERPRINT reader is automatically detected by AC-MAX HW
software if the reader and PC with AC-MAX HW are in the same subnet and communication
between them is not blocked.
Connect
6. Select
7. In the opened window which can also be accessed selecting
menu of AC-MAX HW software, enter such communication parameters as
Default Gate
8. Additionally
communication with the reader.
9. Select the option
EPSO3 protocol settings
FINGERPRINT on RS485 bus of AC-MAX CU access controller in range of 101..115.
All manuals and user guides at all-guides.com
button.
Fig. 6 Select device window in AC-MAX HW software
Subnet mask
and .
define your communication
[2] RS485 EPSO3
below in
AC-MAX FINGERPRINT v1.0
FPAC-MAX v1.0 fv1.4
password for
Communication protocol
in
Address
field assign unoccupied address to FPAC-MAX
device, firmware

Configuration

command in top
IP address
,
securing and encrypting
field and in the area
1.4
and
IP Port
,
the
RS485
22/26