Teac LP-R500 Manual Del Usuario página 27

7 Press the PLAY/PAUSE button (y/J) to start recording.
8 If AUX is selected in step
recorded.
When the playback of the source finishes, press the STOP button
(H) to stop recording.
When playback of a record finishes and the turntable stops
rotating or playback of a cassette tape finishes, recording
automatically ends.
But to prevent unwanted noise from the tone arm being
recorded, stop the recording manually by using the STOP button.
When recording is stopped, "REC" and "-End---" blink for
several seconds. Do not turn OFF the power or shake the unit
during recording or when "REC" and "-----" are blinking. Such
actions prevent proper recording.
1 , play the source to be
To stop recording
A
Press the STOP button (H) to stop recording.
To suspend recording temporarily (pause mode)
B
Press the PLAY/PAUSE button (y/J). "bUSY" briefly appears on
the display, and the recording is paused.
To restart recording, press the PLAY/PAUSE button (y/J).
< You cannot restart recording while "bUSY" is displayed.
< Remember that every time recording is paused or stopped, a
new track number will always be assigned. It is not possible to
record in two "stages" within one track.
< The unit will not stop or pause even if the PLAY/PAUSE button
is pressed within 4 seconds after recording has started.
This is due to a CD specification which allows you stop or pause
only after 4 seconds of recording.
Manual track division
C
It is possible to divide the recording into tracks while recording.
While recording is taking place, press the TRACK INCREMENT
button. The current track number will be incremented by one.
< The TRACK INCREMENT button works regardless of the
MANUAL/AUTO REC setting.
< You cannot divide the track manually for tracks of less than 4
seconds in CD specifications. Up to 99 tracks can be divided on
one single CD.
27