Stihl KB-MM Manual De Instrucciones página 15

Fitting New Deflector
5
7
7
Line up the deflector (5) on the
N
flange (6) and push it onto the drive
tube as far as stop.
Tighten down the clamp screws (7)
N
firmly.
Mounting the Gearbox
1
2
1
Push the gearbox (2) onto the drive
N
tube as far as stop while turning it
back and forth.
Line up the gearbox.
N
Go to "Checking Position of
N
Gearbox".
KB-MM, KW-MM
Checking Position of Gearbox
WARNING
To reduce risk of injury from the
MultiTool rotating in the wrong direction,
check that position of gearbox is correct
and adjust if necessary.
6
The axle (1) must be above the shaft (2).
Direction of rotation (3) of MultiTool.
Adjusting Position of Gearbox
Loosen clamp screws on gearbox.
N
Turn the gearbox through 180°.
N
Line up the gearbox in the correct
N
position.
Tighten down the two clamp screws
N
on the gearbox in the following
sequence:
Tighten the first screw moderately.
–
Tighten the second screw
–
moderately.
Tighten down first screw firmly.
–
Tighten down second screw firmly.
–
NOTICE
It must not be possible to rotate the
gearbox on the drive tube.
Mounting the MultiTool
1 2
Push the grass shield (1) onto the
N
axle (2) as far as stop.
3
2
Push the axle (2) onto the drive
N
shaft (3) as far as stop.
Insert and engage the pin (4) in the
N
axle and through the drive shaft.
English
4
13