Bosch 30-300 Instrucciones De Funcionamiento Y Seguridad página 14

Fig. 8
3
2
1
CHANGING DRIVE
SOCKET ON THE
ANGLE HEAD WITH
EXTERNAL SQUARE
DRIVE
Inserting
– Press in the pin on the
square drive of the angle
head 2, e. g. using a small
screwdriver, and slide the
drive socket 1 over the
square drive. Pay attention
that the pin engages in the
recess of the tool bit (Fig.
8).
Removing
– Press in the pin on the
square drive through the
hole on the side of the
drive socket, then pull the
socket off the square drive
of the angle head 2 (Fig. 8).
160992A3VR.indb 14
All manuals and user guides at all-guides.com
Fig. 9
2
1
CHANGING DRIVE
BIT ON THE ANGLE
HEAD WITH INTERNAL
HEXAGON
Inserting
– Insert the tool bit 1 into the
internal hex socket of the
tool holder 2 until it can be
felt to engage (Fig. 9).
Removing
– Pull the tool bit 1 off of the
tool holder 2 with the aid of
pliers, if necessary (Fig. 9).
14
Fig. 10
1
24
2
1
2
CHANGING DRIVE BIT
ON THE ANGLE HEAD
WITH QUICK-CHANGE
CHUCK
Inserting
Use only insertion tools with
fitting end pieces (1/4" hex-
agonal) .
– Pull the sleeve of quick-
change chuck 24 to the
front and hold (Fig. 10).
– Insert tool bit 1 into tool
holder 2 and release the
quick-change chuck (Fig.
10).
Removing
– Pull the sleeve of quick-
change chuck 24 to the
front and hold (Fig. 10).
– Remove tool bit 1 from tool
holder 2 and release the
quick-change chuck (Fig.
10).
3/7/17 12:22 PM
3