auna Stereosonic Manual De Instrucciones página 43

stored some stations in memory, the number of new stations you can store
will be less.
1. Press the FM button on the remote control or SOURCE button repeatedly
on the main unit to select FM.
2. Press and hold down the RDS ASPM button on the remote control.
3. After "ASPM" has flashed for about 4 seconds, scanning will start (87.50
- 108.00 MHz).
4. When an RDS station is found, "RDS" will appear for a short time and
the station will be stored in memory.
5. After scanning, the number of stations stored in memory will be
displayed for 4 seconds, and then "END" will appear for 4 seconds.
6. To stop the ASPM operation before it is complete:Press the RDS ASPM
button while it is scanning for stations.The stations which are already
stored in memory will be kept there.
Notes
• If the same station is broadcasting on different frequencies, the
strongest frequency will be stored in memory.
• Any station which has the same frequency as the one stored in memory
will not be stored.
• If 30 stations have already been stored in memory, the scan will be
aborted. If you want to redo the ASPM operation, erase the preset
memory.
• If no station has been stored in memory, "END" will appear for a short
while.
• If the RDS signals are very weak, station names may not be stored in
memory.
• The same station name can be stored in different channels.
• In a certain area or during certain time periods, the station names may
temporarily be different.
EN
43