Xiii.connection Diagram - Gastrodomus SLA350 Manual Del Usuario

Blade sharpening
Clean the machine thoroughly as indicated in the previous paragraphs before proceeding with the
operations.
The following instructions should be followed when sharpening the blade, which should be done
periodically as soon as you feel a decrease in cutting capacity:
1. Carefully clean the blade with denatured alcohol in order to degrease it after disconnecting the plug from
the power outlet;
2. Set the thickness to 15mm with the special knob
3. Press the button and let the emery overlap the blade.
4. Start the machine
5. Make sure the emery turns with the blade for about 5-10 seconds.
6. Press the second emery button and hold it down for a few seconds with the blade in motion to remove
any burrs formed in the previous action.
7. Release the second grinder button and turn off the machine.
Lubrication
Lubricate with white Vaseline oil the whole sliding system of the tray and the pressing machine.

XIII.CONNECTION DIAGRAM

Maintenance operations must always be carried out with the machine
disconnected from the power supply and, if no other position is specifically
required, with the slice thickness adjustment knob set to '0'.
Sharpening can be performed up to a decrease of 12 mm of the nominal
value of the blade diameter. Beyond this value it is mandatory to replace
the blade, entrusting the operation ONLY by authorized personnel.
WARNING: Cutting hazard! Use cut and tear resistant protective gloves and
perform all operations with extreme care. DO NOT GET DISTRACTED!
32